Introduction to ABG analysis
Read the physiology, not just the numbers.
14 min read5 questions · 2 synthetic casesIndependent clinical review pending
By the end of this chapter
- Separate pH from the underlying process
- Use a consistent interpretation sequence
- Check the specimen before calculating
Visual physiology
From sample to physiological questions
01 · Source
Arterial, venous or capillary?
02 · Acid–base
pH → CO₂ → bicarbonate
03 · Oxygenation
Arterial PaO₂ + known FiO₂
A small sample. Three important questions.
An arterial blood gas is a snapshot of acid–base balance, ventilation and oxygenation. The pH describes the net hydrogen-ion state. PaCO₂ helps assess alveolar ventilation relative to carbon dioxide production. PaO₂ describes the oxygen partial pressure in arterial plasma; it does not measure total oxygen content or prove adequate tissue delivery.
Start with the specimen, oxygen delivery at sampling, time and clinical context. Then examine pH, identify which change in PaCO₂ or bicarbonate explains its direction, check expected compensation, and assess the anion gap and oxygenation when the necessary inputs are available. An orderly method prevents a striking oxygen result from hiding an acid–base disorder.
Acidemia is a state; acidosis is a process
Acidemia means arterial pH below a typical adult interval of 7.35–7.45. Alkalemia means pH above it. Acidosis is a process that tends to lower pH; alkalosis tends to raise it. More than one process can occur at once. Their effects may partly cancel, leaving a normal-range pH despite important disease.
CO₂ behaves as the respiratory acid component, whereas bicarbonate is the major buffer component. A high PaCO₂ pushes pH downward; a low bicarbonate does the same. A low PaCO₂ or high bicarbonate pushes pH upward. The direction identifies a candidate primary process, not its cause.
TENDS TO LOWER pH
↑ PaCO₂ · ↓ HCO₃⁻
Respiratory or metabolic acid process
TENDS TO RAISE pH
↓ PaCO₂ · ↑ HCO₃⁻
Respiratory or metabolic alkali process
What an ABG can—and cannot—tell you
Blood-gas analyzers usually measure pH, pCO₂ and pO₂ directly and calculate bicarbonate from pH and pCO₂. A chemistry panel measures total CO₂, mostly bicarbonate. These are related but not interchangeable in every setting. Large disagreement calls for verification of specimen timing and handling, not silently choosing a preferred result.
A venous gas can inform selected acid–base questions, but venous pO₂ is not arterial oxygenation. Capillary samples have site and arterialization limitations: capillary pO₂ must never be labelled PaO₂. An interpretation is a physiological description to correlate with examination and other investigations, never an automated definitive diagnosis.
Worked example
A first structured reading
- 1.Synthetic arterial sample: pH 7.31, PaCO₂ 32 mmHg, HCO₃⁻ 16 mmol/L.
- 2.pH 7.31 is acidemia. HCO₃⁻ 16 is low and explains that direction: a primary metabolic acidosis is likely.
- 3.PaCO₂ is also low, but that raises pH rather than causing acidemia. Check compensation: 1.5 × 16 + 8 = 32 ± 2 mmHg.
- 4.Measured PaCO₂ 32 is within 30–34. It is consistent with expected respiratory compensation; investigate the metabolic cause rather than calling this respiratory acidosis.
Common mistakes & exam tips
- Do not diagnose from pH alone, especially when it is normal.
- Do not call every abnormal PaCO₂ a primary respiratory disorder.
- For exams, state the specimen and units before presenting a calculation.
Check your understanding
Five questions to consolidate the chapter
01Which term describes an arterial pH of 7.29?
02Which finding tends to raise pH?
03pH 7.40 guarantees which conclusion?
04What should precede an oxygenation calculation?
05On most blood-gas instruments, bicarbonate is…
Reason through two clinical cases
The apparently normal gas
A synthetic arterial specimen on room air; the collection details are verified.
pH 7.40 · PaCO₂ 40 mmHg · HCO₃⁻ 24 mmol/L · PaO₂ 95 mmHg
A low pH with a low CO₂
Synthetic arterial gas in a patient with deep breathing; no cause has been supplied.
pH 7.31 · PaCO₂ 32 mmHg · HCO₃⁻ 16 mmol/L
Synthetic rounding note
Printed-input HH pH is 7.321849 (display 7.32); the supplied pH remains 7.31. At pH 7.31 and CO₂ 32, inferred bicarbonate is about 15.57, which rounds to 16.
The essentials to take away
- Confirm source and context first.
- Describe the pH state, primary process and compensation separately.
- A normal pH does not exclude a mixed disorder.